When using the microphone in a busy environment, try turning on the Focus Pattern Technology in the Sound Deck Software to ensure you only pick up the sound of your voice.If you find that there is a lot of background noise in your audio, turn on the Active Noise Canceling function in the Sound Deck Software.If you want to only hear the audio back from your software you will need to turn off the direct monitoring. The headphones will provide a mix of the direct signal that the microphone is picking up and the return audio from your software.Turn the microphone level control down until it no longer flashes red. If you see the peak indicator illuminate red, your signal will be distorted. Set the level of the Go Mic Connect by slowly raising the level of the microphone while talking or singing into the microphone at the performance level.Launch your audio software and select the Go Mic Connect as the audio input and output devices.I’ve been putting this problem aside for a while now but the mic does not like to work as I would expect. I’m using it in my room for recording videos as well as online classes. If you are using headphones, connect your headphones or speakers to the headphone output located on the rear of the Go Mic Connect. So a little while back I bought the Samson G Track Pro and did my best to set it up.Connect the included USB cable from the microphone into an available USB port on your computer.
Position the microphone so that it is facing the sound source.Affix the Go Mic Connect to a monitor or arrange it on a flat service.
